Targus USB Mobile Port Replicator Manual de usuario descargar pdf (Pagina 8)

CONNECTING DEVICES TO THE PORT REPLICATOR

When connecting a new device to any port on the port replicator, the

corresponding software drivers must be installed. Consider the following

guidelines when preparing to connect new devices:

Ÿ If your operating system is Windows 98, you will be prompted by

a series of screens beginning with Add New Hardware Wizard.

You may need your Windows 98 CD to complete the installation

of the neccessary device driver.

Ÿ If your operating system is Windows 2000, the device driver will

install automatically.

Ÿ With either operating system, you must run the Setup or Install

that was included with your device.

Ÿ To load any device-specific software, assign the device to a port

as follows:

parallel printer PB1284-1 (USB port)

serial mouse or modem serial USB (COMx) where x is the

number of the COM port

PS/2 mouse or keyboard no port name required; the device

will be converted to emulate a USB

mouse or keyboard.

Installing a Serial Mouse

After connecting a standard serial mouse to the serial port on the port

replicator, press the Reset button until the Link LED flashes (about 5

seconds). Pressing the Reset button resets the serial port. Do this each time

you restart your notebook computer and whenever connecting a serial device.

Installing a Serial Modem

Follow your modem installation instructions to add this device to your port

replicator. When prompted to select the port, choose the Serial USB (COMx),

where x is the COM port number assigned by your operating system.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Targus USB Mobile Port Replicator Manual de usuario Pagina 8